The MACHINE has automatic feeding arrangement in longitudinal, cross and vertical direction, having selection from different speeds. The milling spindle is fitted in two taper roller bearings. The different spindle speeds which are in geometrical progression are obtained by means of sliding gears, by which only such gears come into mesh which are necessary for the desired speed. All the gears run in oil-bath the wear thus being minimized.The table has a strong cross section and a coolant groove, fitted with a strainer at the draining point. The table screw has ph. bronze nut which minimizes wear and tear. The table screw is mounted on taper bearings which takes the axial load of the screw.

The knee is well braced by internal partition walls giving it the greatest stability. In all respects, it has been carefully designed with wide slide surfaces which gives a rigid support to saddle and table. The vertical screw for raising & lowering the knee is provided with thrust bearings for taking the vertical load. The feed gear box is built on side of the knee.
The base, which at the same time serves as a coolant tank is simple dimensioned and heavy. The coolant pump and coolant pipes are so dimensioned that enough coolant is supplied to the cutter.
The column owing to its special form is very rigid and all guides are hand scraped.

(The rights of alteration in design, construction and specification reserved)